Response Timeout

Usage:	Only used when a response is required from the host. While in Multidrop, if the Imager does not receive an ACK or NAK from the host after sending polled data, it will act on a fault. The reader can be set to wait indefinitely by setting Response Timeout to zero.
Definition:	The time that the Imager will wait before timing out if ACK, NAK, and ETX are enabled, and a host response is expected.
Serial Cmd:	<K143,response timeout>
Default:	12 (in 1mS increments)
Options:	0 to 255 (A zero (0) setting causes an indefinite wait.)

Note: See USB HID Interface for protocol information relating to USB.