Changing Network Parameters

To change network parameters:

• Start a HyperTerminal session with the communication parameters set to
  115200-No Parity-8-1-No Flow Control.

• While you hold down the Escape key, cycle power on the VS-1 Smart Camera. Information similar to the following is displayed:

HawkEye Smart Camera
400MHz 16MB Flash 64MB RAM
-----------------------------
Name: HawkEyeE1000E
Static IP: 161.218.121.183
Network Mask: 255.255.255.0
Gateway: 0.0.0.0
DHCP: 1
MAC Address: 00:60:33:e1:12:34
1. Modify User Parameters
2. Reset User Account
3. Exit to Application
>>

• Type 1 to begin stepping through network parameters.

• For each parameter that is displayed, simply type in new information (to change the parameter), or press the Return key to display the next parameter. Eventually, you'll see the message "Save parameters to flash? [y/n] -

• Type y and press the Return key. You're finished changing network parameters.