QuicSet® Switch

Note: On earlier production units only. The QuicSet function is not used on the VS-1 Smart Camera.

Figure A-5 shows the location of the QuicSet switch and access screw.

FIGURE A-5. 

QuicSet® Switch and Access Screw "S1" - Rear View

The QuicSet switch is located beneath the access screw, as shown at location S1 in Figure A-5. To access the QuicSet Switch, remove the sealing screw with a Phillips screwdriver. To maintain the IP rating of the chassis, the sealing screw must be installed and tightened to 0.6 Nm. If IP rating is not critical to your application, hand tighten snug. Do not overtighten!