PreviousNext

Main Menu Items

Modify User Parameters

This utility allows you to change network configuration values. You are prompted to enter each parameter one at a time. To enable DHCP, for example, the sequence is as follows:

>> 1
Default network name: HawkEye™ 1600T_Test -
Static IP: 161.218.121.183 -
Subnet mask: 255.255.255.0 -
Gateway: 0.0.0.0 -
Use DHCP: 0 - 1
Save parameters to flash? [y/n] - y

Saving boot parameters to flash......done.

  • Network Name - This is limited to 19 characters. Any input string longer than 19 characters is truncated automatically to the first 19 characters. The string is erased by entering the '.' (period) character.
  • Static IP, Subnet Mask, Gateway - These must contain an address in valid IP format. If you enter an invalid address, you are prompted to re-enter the value until a valid address is entered or the Enter key is pressed (effectively skipping the update for this field).
  • DHCP - The value for DHCP value is either a 0 (zero) or 1 (one).
  • MAC Address - You cannot change the MAC Address, since this is set in the factory.
PreviousNext