USB Cable Installation

To connect the HE40T to your host computer via USB interface:

• Make sure the USB cable is sufficiently attached to your HE40T reader (Figure 1-11 and Figure 1-13).

FIGURE 1-14. 

Connecting the USB Cable

• You DO NOT need to power off your host computer (Figure 1-14). The HE40T with USB interface can be plugged into any host while the computer is powered up.

• Connect the USB interface cable to the host (Figure 1-14). If you are unsure of the proper location to connect the USB cable, please consult the manual of your host computer.

• The USB interface does not require an additional power supply. If you are using a battery handle (BH1 or BH2) for batch mode, the HE40T will automatically recharge the battery whenever the reader is a attached to a host that is powered up.

• The HE40T will power on automatically.

• Scan the USB Keyboard Mode code and then the Save Settings code to configure the reader:

FIGURE 1-15. 

USB Keyboard Mode & Save Setting Codes

• Your HE40T reader should be ready for use. Open the application on your host computer that you wish to send data to and begin scanning.