PreviousNext

Connecting the MS-Connect 210 to a Host

Once you have a reader connected to the MS-Connect 210 by RS-232, you have the option of connecting the MS-Connect 210 to a host computer.

  • Unscrew one of the three CGB caps at the back of the unit.

  • Clear the CGB's access hole to create a cabling route into the box.
  • Pass a pre-stripped RS-232 Host Cable (P/N 61-000105-01) through the access hole so that the 9-pin connector is outside the box, and the end to be wired is inside the box.
  • Wire the Host Cable to the "Host RS-232" terminal block (J13).
  • Connect the Host Cable to the host's RS-232 port.

PreviousNext