PreviousNext

Connecting an MS-Q Imager to the MS-Connect 210

Once you have a reader connected to the MS-Connect 210 by RS-232, you can simultaneously connect an MS-Q by wiring it directly to the MS-Q terminal block inside the box (J15).

  • Unscrew one of the three CGB caps at the back of the unit.
  • Clear the CGB's access hole to create a cabling route into the box.
  • Pass a pre-stripped MS-Q Reader Cable (61-000066-02 or user-supplied) through the access hole so that the reader connector is outside the box and the end to be wired is inside the box.

  • Wire the MS-Q Reader Cable to the MS-Q terminal block (J15).

PreviousNext