PreviousNext

Connecting a 5-Volt Reader to the MS-Connect 210

If you are using an MS-3, MS-3 CCD, MS-4, Quadrus MINI, Quadrus MINI 3, or Quadrus MINI Velocity:

  • Tighten the cable housing at the 19-pin reader connector on the back of the MS-Connect 210 unit.
  • Attach the 15-pin end of the Reader Cable to the 10-28VDC end of the IC-332 Power Adapter, and attach the reader's cable to the 5VDC end of the IC-332 Adapter.

Important: Reversing the IC-332 in this configuration may seriously damage the interface.

  • Attach cabling inside the wiring box.
  • Attach an Object Detector (optional) to the MS-Connect 210 via the trigger Micro-Change connector, shown in the illustration below.
  • Attach the Power Supply to the MS-Connect 210 via the power Micro-Change connector, shown in the illustration below.



PreviousNext